Furnace Repair in Porter County and Northwest Indiana
24/7 furnace repair across Porter, Lake, and LaPorte Counties
When your furnace stops working in the middle of a Northwest Indiana winter, you need it fixed fast and fixed right. Apex Heating & Cooling is a veteran-owned furnace repair company based in Valparaiso and serving homeowners throughout Porter County and parts of Lake and LaPorte Counties. We repair all major brands, including Armstrong, Lennox, Carrier, Trane, and Goodman.
24/7 Emergency Furnace Repair
No heat at 2 a.m. is an emergency, so we treat it like one. Apex answers emergency furnace repair calls throughout Porter County and the surrounding area around the clock, including nights, weekends, and holidays. For no-heat situations we do our best to get to you the same day, though we can't promise it every time.
Before you call, it takes a minute to check that the thermostat is set to heat and a few degrees above the room temperature, that the furnace switch and breaker are on, and that the air filter is not clogged. If a quick check does not bring the furnace back, call us. If you smell gas or your carbon monoxide alarm sounds, leave the house and call 911 and your gas utility from outside.

Licensed, Bonded & Insured
All Major Brands Repaired
Emergency Service
Competitive Pricing
We repair gas furnaces of every major brand, including Armstrong, Lennox, Carrier, Trane, and Goodman. These are the problems we see most often, and what they usually mean.
- Furnace will not turn on or will not ignite. This is often a failed ignitor, a dirty flame sensor, or a problem with the control board or gas supply. A furnace that shuts itself down instead of lighting is doing what it is designed to do, but it still needs to be diagnosed.
- Furnace blowing cold air. If the burners are not staying lit, the blower can keep running and push out unheated air. A dirty flame sensor, or a furnace that overheated because of a clogged filter, are two common reasons.
- Short cycling. A furnace that turns on and off every few minutes is often overheating from restricted airflow or losing its flame signal. It wears out parts faster and should not be ignored.
- Banging, rattling, or screeching. Banging can point to delayed ignition, rattling to loose panels or ductwork, and screeching to a worn blower motor or bearing. If your furnace is making loud noises, turn it off and call us rather than running it.
- Blower motor problems. Weak airflow, a furnace that gets hot but moves little air, or a motor that hums and will not start usually means the blower motor or its capacitor needs attention.
- Thermostat and control faults. A furnace that does not respond, or does not match the temperature you set, may have a thermostat, wiring, or control board issue rather than a failed furnace.
- Uneven heat from room to room. Closed or blocked vents, a dirty filter, duct leaks, and a weak blower can all cause it. We will tell you whether the cause is the furnace or the ductwork.
Furnace Problems We Repair
We repair gas furnaces of every major brand, including Armstrong, Lennox, Carrier, Trane, and Goodman. These are the problems we see most often, and what they usually mean.
Furnace will not turn on or ignite
Often a failed ignitor, a dirty flame sensor, or a problem with the control board or gas supply. A furnace that shuts itself down instead of lighting is doing what it is designed to do, but it still needs to be diagnosed.
Furnace blowing cold air
If the burners are not staying lit, the blower can keep running and push out unheated air. A dirty flame sensor, or a furnace that overheated because of a clogged filter, are two common reasons.
Short cycling
A furnace that turns on and off every few minutes is often overheating from restricted airflow or losing its flame signal. It wears out parts faster and should not be ignored.
Banging, rattling, or screeching
Banging can point to delayed ignition, rattling to loose panels or ductwork, and screeching to a worn blower motor or bearing. If your furnace is making loud noises, turn it off and call us rather than running it.
Weak airflow and uneven heat
Weak airflow, a furnace that gets hot but moves little air, or heat that varies from room to room can come from a failing blower motor or capacitor, a dirty filter, blocked vents, or duct leaks. We will tell you whether the cause is the furnace or the ductwork.
Thermostat and control faults
A furnace that does not respond, or does not match the temperature you set, may have a thermostat, wiring, or control board issue rather than a failed furnace.
How a Furnace Repair Visit Works
- You call us. Emergency furnace calls are answered 24/7.
- We diagnose the problem. We inspect the furnace and explain what failed and why.
- You get the price first. No work starts until you approve a clear price.
- We make the repair. Many repairs can be finished in a single visit, depending on the part that is needed.
- We test the system. We confirm your furnace is running safely before we leave.

Furnace Safety: When to Stop and Call
Most furnace problems are an inconvenience. A few are not. Know the difference before you decide to wait.
- If you smell gas or your carbon monoxide alarm sounds, get everyone out of the house and call 911 and your gas utility from outside. Do not try to find the cause yourself.
- If you notice a burning smell that does not go away, banging, or screeching, turn the furnace off at the thermostat and call us.
- If the burner flame looks mostly yellow instead of blue, or you see soot around the furnace, turn it off and call us. These can be signs the furnace is not burning properly.
Make sure there is a working carbon monoxide alarm on every level of your home and near the bedrooms, and test it regularly. A furnace that is cracked, poorly vented, or not burning properly can release carbon monoxide, which you cannot see or smell.
Repair or Replace?
Most furnace repairs are worth making. The real question is whether the furnace you have is worth putting more money into. These are signs that replacement may be the better choice:
- The furnace is 15 years old or more. Many last about 15 to 20 years, depending on the model and how well it has been maintained.
- Repairs are happening more often.
- The heat exchanger is cracked. This is a safety issue, and it usually means the furnace should be replaced.
- Energy bills keep climbing, or some rooms never get comfortable.
We tell you what is wrong and lay out your options, so the decision is yours. If replacement is the better choice, you can learn more about our furnace installation services. Financing is available for larger repairs and full replacements.
Furnace Repair Across Porter County and Surrounding Areas
Apex is based in Valparaiso and provides furnace repair throughout Porter County, including Valparaiso, Portage, Chesterton, Porter, Burns Harbor, Hebron, Kouts, Wheeler, and Boone Grove. In Lake County, we serve Hobart, Merrillville, and Lakes of the Four Seasons. We also serve parts of LaPorte County, including Westville.
Furnace Repair Questions
-
What are the most common furnace problems in Northwest Indiana homes?
The furnace repairs we see most often are dirty flame sensors, failed ignitors, clogged filters, worn blower motors, and thermostat faults. Long cold stretches in Northwest Indiana keep furnaces running for hours at a time, so small problems tend to show up in December and January. Most can be repaired in a single visit.
-
Why is my furnace blowing cold air?
Usually the burners are not staying lit while the blower keeps running. A dirty flame sensor, a failed ignitor, or a furnace that shut its burners off because it overheated from a clogged filter are common causes. It can also be as simple as the thermostat fan being set to ON, which runs the blower between heating cycles. Check the thermostat and the filter first. If the air is still cool, give us a call.
-
Why does my furnace keep turning on and off?
A furnace that cycles on and off every few minutes is short cycling. It is often caused by restricted airflow from a dirty filter or blocked vents, which makes the furnace overheat and shut down, or by a flame sensor that is not detecting the flame. Replacing the filter is a reasonable first step. If it keeps happening, have the furnace looked at, because short cycling wears out parts.
-
How much does furnace repair cost in Northwest Indiana?
Furnace repair cost depends on which part has failed and how the system is built, so an honest number requires a diagnosis. We inspect the furnace, tell you what is wrong, and give you the price before we start. Financing is available for larger repairs and full replacements.
-
Is a burning smell or loud noise from my furnace dangerous?
It can be. A brief dusty smell the first time you run the heat each fall is normal. A lasting burning smell, banging, or screeching means you should turn the furnace off and call for repair. If you smell gas or your carbon monoxide alarm sounds, leave the house and call 911 and your gas utility from outside.
-
Do you repair every brand of furnace?
We repair gas furnaces of every major brand, including Armstrong, Lennox, Carrier, Trane, and Goodman. Call us with the brand of your furnace and what it is doing, and we will tell you what to expect.
-
Should I repair or replace my furnace?
It depends on the age of the furnace, how often it needs repairs, and what is wrong. A furnace that is 15 years old or more, needs frequent repairs, or has a cracked heat exchanger is usually a candidate for replacement. We explain the problem and your options so you can decide. Financing is available for larger repairs and full replacements.

What Our Customers Say About Us
"Very nice, knowledgeable, and responsive. helped us with our furnace issue and even pointed out a concern with our water heater that could've lead into a bigger problem. fair pricing. will absolutely recommend to friends and family. Thank you Ed!"
Contact us any time
Contact us any time
We will get back to you as soon as possible.
Please try again later.






